20 32 6 oil seal

The mention of 55%, 80%, and 10% in relation to oil seals might reflect various metrics or considerations concerning their performance and application. For example, in many mechanical systems, seals can be categorized based on their efficiency, effectiveness in preventing leakage, and their material composition. A 55% rating might refer to a baseline performance measure for standard oil seals, whereas an 80% rating could indicate high-performance seals designed for rigorous applications. On the other hand, a 10% figure could relate to the failure rate or the operating conditions under which these seals can be compromised.

Material Selection

In the process of composite electroplating galvanized wire, the plating solution must be stirred to obtain the composite coating in which the particles dispersed in the matrix metal. Stirring methods include mechanical stirring, air stirring, ultrasonic stirring, bath circulation, etc. The acid activation solution in the production process can remove the corrosion products and oxide film on the surface of the low carbon steel wire without excessive corrosion on the matrix.

The difference is that hot dip galvanizing is dipped in zinc solution melted by heating, which has fast production speed and thick but uneven coating. The color is dark, the consumption of zinc metal is much, the formation of infiltration layer with the matrix metal, the corrosion resistance is good, and the outdoor environment of hot dip galvanized can be maintained for decades. Cold galvanized is in the plating tank through the current unidirectional zinc gradually plated on the metal surface, the production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust.