Hebei Hankai replacing seals in a hydraulic cylinder

The designation 35x72x10 refers to the dimensions of the oil seal in millimeters. Here, 35 is the inner diameter (ID), 72 is the outer diameter (OD), and 10 is the width or thickness. The 20 in the specification may refer to a particular feature or code linked to manufacturing standards or specific application characteristics.

High pressure hydraulic shaft seals can be categorized into several types, including

The TCN oil seal is constructed from a compound known as nitrile rubber (NBR), which is known for its excellent resistance to petroleum-based oils, fuels, and other chemicals. The triple-chamber design of the TCN seal/contains three distinct sealing lips that enhance its ability to maintain a tight seal, thereby preventing fluid leakage and protecting machinery components from contaminants.

The Rebuilding Process

Once you have your seal kit, it is time to start the repair process. Start by lowering the jack all the way down and removing the oil filler plug. Drain out any remaining oil and remove the ram from the jack. Carefully disassemble the jack, taking care to keep track of where each part goes.

In recent years, the issue of seal dust has emerged as a topic of interest within various scientific and environmental spheres. Seal dust is composed of the minute particles and organic materials shed by seal populations, particularly in regions where seals congregate for breeding and resting. While often overlooked, this phenomenon has significant implications for both marine ecosystems and human activities.

Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.

Many people do not know how to choose high quality cut wire, I will give you a detailed introduction. The raw material of cutting wire is divided into: stainless steel cutting wire, copper cutting wire, steel wire cutting wire, copper plated steel wire cutting wire, galvanized steel wire cutting wire, iron wire cutting wire, aluminum wire cutting wire and so on.

Generally, the main reasons for the rust of iron wire are: when the steel mesh in the metal mesh appears some dust, this time you can use some water or alkaline solution cleaning. Followed by floating iron or embedded iron, iron will rust, connected to the stainless steel plate mesh of iron rust, so these iron must be dealt with, can use carbon steel wire brush can also be used for processing carbon steel and so on. Then is the scratch, for the scratch, mainly in the production process, need some stubborn iron scratch stainless steel plate net special polishing cleaning machine.